- DL manuals
- Yamaha
- Amplifier
- XP1000
- Owner's Manual
Yamaha XP1000 Owner's Manual
Summary of XP1000
Page 1
Power amplifier owner’s manual bedienungsanleitung mode d’emploi manual de instrucciones es fr de en english deutsc h f rançais español.
Page 2: Fcc Information (U.S.A.)
2 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual the above warning is located on the top of the unit. Explanation of graphical symbols the lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within t...
Page 3: Precautions
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 3 precautions please read carefully before proceeding * please keep this manual in a safe place for future reference. Warning always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical sh...
Page 4
4 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual • when turning on the ac power in your audio system, always turn on the device last, to avoid speaker damage. When turning the power off, the device should be turned off first for the same reason. • do not insert your fingers or hands in any gaps o...
Page 5: Introduction
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 5 introduction thank you for purchasing a yamaha xp7000, xp5000, xp3500, xp2500, xp1000 series power ampli- fier. The xp series of power amplifiers was developed from yamaha’s wealth of experience in building pa equipment and its tradition of careful...
Page 6: Controls and Functions
6 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual controls and functions ■ front panel 1 power switch and indicator press this to turn the power on or off. The power/ standby indicator lights up in green when the power is on. If the amplifier has been set to standby mode, the indicator is lit in o...
Page 7: Rear Panel
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 7 ■ rear panel 1 xlr inputs connectors these balanced xlr-3-31 type connectors are used to connect input signals. The pins are wired as shown below (iec 60268). * in bridged mode, only the first channel in the pair is active; i.E., channel a of pair ...
Page 8: Speaker Connections
8 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual speaker connections speakers can be connected to the amplifier in three ways, as shown below. Note that speaker impedance will vary according to the connection method and the number of speakers. Please be sure that your speaker's impedance is not l...
Page 9
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 9 ■ bridged mode (use as high-power mono amplifier) set the mode switch to bridge to use the unit as a high-power mono amplifier. The volume control a on the front panel a lets you control the volume. ● 5-way binding post ● speakon connector note: in...
Page 10
10 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual high-impedance speaker connections (xp7000/3500 only) the xp7000 enables you to connect in stereo or parallel fashion multiple high-impedance speakers that support 70v line output. The number of speakers that can be connected varies depending on t...
Page 11: Connection
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 11 connection ■ using a euroblock connector 1 if the wire insertion ports are closed, turn the screws on top of the connector counterclockwise to open the ports. 2 insert the wires into the appropriate ports, following the indication of the pole on t...
Page 12: Troubleshooting
12 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual troubleshooting the following table lists the main causes of abnormal operation and the corrective measures required as well as the protec- tive circuit operation in each case. ● xp3500, xp2500 ● xp7000, xp5000 indicator(s) possible cause remedy p...
Page 13: Specifications
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 13 specifications ■ general specifications xp7000 120 v 230 v 240 v output power 1 khz thd+n= 1 % 8 Ω/stereo min 750 w + 750 w 750 w + 750 w 750 w + 750 w 4 Ω/stereo 1100 w + 1100 w 1100 w + 1100 w 1100 w + 1100 w 8 Ω/bridged 2200 w 2200 w 2200 w 20 ...
Page 14
14 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual * these specifications apply to rated power supplies of 120v, 230v and 240v. 0 dbu=0.775 vrms, half power=1/2 output power (3 db below rated power) specifications and descriptions in this owner’s manual are for information pur- poses only. Yamaha ...
Page 15: Monitor/remote Pin Layout
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 15 ■ monitor/remote pin layout ■ dimensions unit: mm pin no. Signal description 1 gnd 2 remote control standby standby control: supply 5 vdc, 5 madc 3 monitor model id xp7000: 1.0 k Ω, xp5000: 1.2 kΩ, xp3500: 1.5 kΩ, xp2500: 1.8 k Ω, xp1000: 2.2 kΩ (...
Page 16: Block Diagram
16 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual ■ block diagram ● xp7000/xp5000 input euroblock xlr xlr [+22dbu max] ch a ch b g – + + g – 3 12 3 12 ha inv pa acl +90˚c +60˚c +90˚c +100˚c +60˚c pr speakon speakon b output level a output level mute protect status standby model id 5way + + – – ch...
Page 17
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 17 ● xp3500/xp2500/xp1000 input euroblock xlr xlr [+22dbu max] ch a ch b g – + g – + 3 12 3 12 ha inv pa acl +90˚c 130˚c +60˚c b ry b dc a dc a ry pr speakon speakon b output level a output level mute protect status standby model id 5way + + – – ch b...
Page 18: Current Draw
18 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual ■ current draw xp7000 xp5000 xp3500 xp2500 xp1000 1/8 power is typical of program material with occasional clipping. Refer to these figures for most applications. 1/3 power represents program material with extremely heavy clipping. Test signal: pi...
Page 19: Memo
Xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual 19 memo.
Page 20: Memo
20 xp7000/xp5000/xp3500/xp2500/xp1000 owner’s manual memo.
Page 22
C.S.G., pro audio division © 2005 yamaha corporation 305poapx.X-01e0 printed in vietnam wf37200 yamaha pro audio global web site: http://www.Yamahaproaudio.Com/ yamaha manual library: http://www.Yamaha.Co.Jp/manual/.