Yamaha YID-W10 Owner's Manual - 3: Playback
4
En
1 Connect your iPod/iPhone to the
transmitter.
The green LED on the transmitter (YIT-W11TX)
and blue LED on the receiver (YIR-W10) light up
if a wireless connection between the transmitter
and receiver is established.
2 Start playback on your iPod/iPhone.
Operation and function depend on your iPod/
iPhone model and Yamaha component. Refer to
the owner’s manuals supplied with your iPod/
iPhone and Yamaha component.
• In case noises are output from the speaker, place
the receiver away from your Yamaha component.
• The transmitter is powered by the battery of your
iPod/iPhone. When your battery of iPod/iPhone
becomes empty, charge your iPod/iPhone.
y
• The transmitter stops wireless communication
automatically after a short time you stop iPod/
iPhone playback.
• To disconnect the iPod/iPhone from the
transmitter, pull it upward.
Transmitter LED status
Receiver LED status
3: Playback
Status LED
Status LED
Notes
LED
Status
Lights up green
Wireless communication between the transmitter and receiver is
established.
Flashes green once
Adjusting the volume level.
Flashes green continuously
Connection in progress, please wait.
Flashes red once
The volume of Yamaha component is set to maximum or
minimum.
Flashes red for 2 seconds
An unsupported iPod is connected.
Flashes red continuously
Error occurs. Remove the iPod/iPhone from the transmitter, and
connect again.
Flashes red 2 times continuously
The battery of the iPod/iPhone is low.
Off
An iPod/iPhone is not connected or wireless communication has
not been established.
LED
Status
Lights up blue
Wireless communication between the transmitter and receiver is
established.
Flashes blue once
Adjusting the volume level.
Flashes blue
Connection in progress, please wait.
Flashes blue rapidly
Error occurs. The receiver is in need of repair.
Off
An iPod/iPhone is not connected or wireless communication has
not been established.