Yamaha YSP-3300 Owner's Manual - Initial Settings
21
En
PR
EPARA
TION
PL
AYBACK
SET
TINGS
TRO
UBLE
SHO
OTI
NG
A
PPEN
DIX
Initial settings
Yamaha’s proprietary yAired technology enables the wireless
connection of the center unit and subwoofer. Wireless connection
of the subwoofer allows for subwoofer installation without
concern for cables. When the transmitter (YIT-W12TX) is used,
iPods or computers can be connected wirelessly to play music
stored on these devices through this unit.
For details of YIT-W12TX, refer to “Safety and Accessory
Information” (separate booklet).
When playing content from a TV or Blu-ray disc player, the
center unit transmits audio signals that are received by the
subwoofer. When YIT-W12TX is used to play songs stored on an
iPod or computer, YIT-W12TX sends audio signals that are
received by the center unit and subwoofer.
The same group ID must be assigned to all components. By
default, the center unit, subwoofer, and YIT-W12TX are assigned
a group ID of A1. This group ID does not need to be changed.
The center unit, subwoofer, and YIT-W12TX can be assigned a
group ID from three possible sets: A1–A3, B1–B3, C1–C3.
A1–A3, B1–B3: Audio delay is less than that of the C1–C3 set.
C1–C3: Use when playing music stored on a computer via this
unit (
☞p. 48).
To prevent wireless connection of another yAired Yamaha sound
system or device installed near this unit or the YIT-W12TX,
assign a different group ID to this unit and the YIT-W12TX.
Changing the group ID
Center unit
Change the group ID from “GROUP ID” in the setup menu
(
☞p. 64).
Subwoofer
Use the group ID switches on the back of the subwoofer to
change the group ID (
☞p. 20).
YIT-W12TX
Use the group ID switches on the side of YIT-W12TX to change
the group ID. For details of YIT-W12TX, refer to “Safety and
Accessory Information” (separate booklet).
Visual operation of this unit
is possible by displaying its
menu screen on the TV.
Use the button for switching
between input sources on the
TV’s remote control to
select this unit.
When this unit and the TV
are connected as shown
below, select “HDMI 1”.
The menu display
The setup menu is displayed on the TV screen when the SETUP
key is pressed. When the TV is receiving HDMI signals, the
menu is superimposed over video content. Press the SETUP key a
second time to cancel setup menu display.
Establishing a wireless connection
Group IDs
Displaying the menu screen on the
TV
TV remote control (example)
Switch
input
sources
HDMI INPUT
1
2
3
TV
this unit
SETUP MENU
BEAM
SOUND
HDMI
yAired
DISPLAY
INFORMATION
IntelliBeam
HORIZONTAL ANGLE
BEAM TRAVEL LENGTH
FOCAL LENGTH
IMAGE LOCATION
CHANNEL OUT
The setup menu (
☞p. 58) can only be displayed on a TV screen. It
cannot be shown in the front panel display.
Note