Z-cyber Zing 7 Seven User Manual - page 11
7” Digital Photo Frame
- 11 -
- Alarm enable : When it is set to “on”, the function of “alarm” is activated;
- Alarm time : Set the alarm time
- Power on enable : When it is set to “on”, the function of “timer power on” is activated
- Power off enable : When it is set to “on”, the function of “timer power off” is activated
- Set time : Set the time of “Power on “ or “Power off”
Q. Firmware upgrading
1. Copy the firmware in a USB flash drive without any file in it.
2. Insert it into the photo frame, press the button of “photo” on remote control, then the firmware
will be loaded to the photo frame; please don’t shut down it during upgrading;
3. When the upgrade is finished, it will reboot; after that , you should delete the firmware in USB
flash drive otherwise the firmware will be upgraded again.