Z-Wave DCH-Z310 Manual - page 2
2
Reset
Notice: Use this procedure only in the event that
the primary controller is lost or otherwise
inoperable.
1.
Press the button four times within 1.5 seconds and
do not release the button in the 4
th
pressed, and
the red LED will light ON.
2.
After the red LED flash 9 times, release the button
within 2 seconds.
3.
IDs are removed and all settings will reset to
factory default.
Association
1.
Have Z-Wave
TM
Controller entered association
mode.
2.
Press the button three times within 1.5 seconds to
enter the association mode.
Note: The device supports 1 group. This group is for
receiving the report message, like triggered event etc.
This group supports 8 nodes maximum.
Failed or success in add/remove the node ID can be viewed
from Z-Wave
TM
Controller.
Notice 1:
Always RESET the Z-Wave
TM
device before trying to add it to
a Z-Wave
TM
network
Notice 2:
When the device into NWI mode, the sensor functionality
will useless. The NWI mode will timeout after 2 minutes. You can press
the button 3 times to abort the NWI mode.
Z-Wave
TM
Notification
After the device is added to the network, it will wake-up once per day
in default. When it wake-up it will broadcast the “Wake Up Notification”
message to the network, and wake-up for 10 seconds to receive the
setting commands.
The wake-up interval minimum setting is 30 minutes, and maximum
setting is 120 hours. And the interval step is 30 minutes.
If the user wants to wake-up the device immediately, please press the
button once. The device will wake-up 10 seconds.
Z-Wave
TM
Message Report
When Smoke Sensor detects, the device will report the trigger event
and also report the battery status.
In default the device will use Notification Report to represent the
trigger event, it can be changed to Sensor Binary Report by setting the
configuration NO. 7 Bit4 to 1.
* Smoke Detected/Test Report:
When the Smoke Sensor detects smoke, the device will unsolicited to
send the smoke detected (0x02) report to the nodes in the group 1.
When the device is in alarm test mode, the device will unsolicited to
send the Smoke Sensor test (0x03) report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Smoke (0x01)
Event: Smoke detected, Unknown Location (0x02)
Smoke Alarm Test (0x03)
Sensor Binary Report (V2)
Sensor Type: Smoke (0x02)
Sensor Value: 0xFF