Z-Wave ST814 Owner's Manual - page 3
3
Note: After removing batteries, please wait for 5 seconds before replacing them.
Operation
There are 8 modes available for selection. Press
to select desired mode
for different settings.
Mode Function
1
Current temperature display (°C/°F)
2
Current humidity display (%)
3
Setting for temperature trigger-ON value
4
Setting for temperature trigger-OFF value
5
Setting for humidity trigger-ON value
6
Setting for humidity trigger-OFF value
7
Setting for turning on/off Radio Frequency
8
Setting for turning on/off beep tone
MODE 1 & MODE 2 are showing as main displays on the screen. Once mode
setting is finished (MODE 3 to MODE 8), the screen will return to main display
automatically after 12 seconds, or by pressing
to return to main display.
1. Temperature
1.1 Display of Current Temperature
Press
and select MODE 1 to display current temperature, and toggle
to select the unit of temperature (。C /。F).
The temperature ranges from -20。
C to 50。
C . To show the last record of max/min
temperature, press
or
. To clear the record, press both
and
at the same time.
Threshold Limit Warning:
If the temperature is reaching the limit, the icon of MAX or MIN will be displayed
on the screen.
Ice Warning:
If the temperature falls to 0。
C , temperature display will illuminate with LCD back
light and beep tone will sound continuously for 1 second. Press any key to stop
the beep tone.
1.2 Temperature Trigger-ON
Press
and select MODE 3 to enter setting of temperature trigger-ON.
Icon
flashes and the screen shows the recorded trigger-ON temperature. If
no value is preset, the screen will display “
- - -。C ”.
To adjust trigger-ON value, press and hold
for 5 seconds until a long
beep is sounded. The “
- - -” starts flashing. Use
and
button to
adjust the degree of temperature, and hold
or
button to scan
through the temperature reading from -20。
C to 50。
C . Once the value is selected,
press
to confirm setting or press
to cancel.
To clear the trigger-ON record, press both
and
at the same time.
The record is cleared after a long beep is sounded.
If the temperature reaches the preset trigger-ON value, Temp./Humid. Detector
will emit RF signal. The screen of detector returns to MODE 1 and the icon
is flashing with backlight illuminate and beep tone sounds for 1 second.
Press any key to stop the beep tone.
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Mode 8