Z-Wave ZME_KFOB Manual - page 6
Frame. Any button press on Key Fob at this stage will terminate the process.
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt
the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow to configure signed values. In order to set values in the range 128 … 255
the value sent in the application shall be the desired value minus 256. For example: to set a parameter to 200 it
may be needed to set a value of 200 minus 256 = minus 56. In case of two byte value the same logic applies:
Values greater than 32768 may needed to be given as negative values too.
Button 1 and 3 pair mode (Parameter Number 1, Parameter Size 1)
In separate mode button 1 works with group 1, button 3 with groups 3. Click is On, Hold is dimming Up, Double
click is Off, Click-Hold is dimming Down. In pair button 1/3 are Up/Down correspondingly. Click is On/Off, Hold is
dimming Up/Down. Single clicks works with group 1, double click with group 3.
Value
Description
0
Separately
1
In pair without double clicks (Default)
2
In pair with double clicks
Button 2 and 4 pair mode (Parameter Number 2, Parameter Size 1)
In separate mode button 2 works with group 2, button 4 with groups 4. Click is On, Hold is dimming Up, Double
click is Off, Click-Hold is dimming Down. In pair button 2/4 are Up/Down correspondingly. Click is On/Off, Hold is
dimming Up/Down. Single clicks works with group 2, double click with group 4.
Value
Description
0
Separately
1
In pair without double clicks (Default)
2
In pair with double clicks
Action on group 1 (Parameter Number 11, Parameter Size 1)
In Switch On/Off only mode On command is sent on Dim Up, Off on Dim Down. In Scenes mode the scene ID sent
is (10 * group + ActionID), where ActionID is: 1 = On, 2 = Off, 3 = Dim Up Start, 4 = Dim Down Start, 5 = Dim Up
Stop, 6 = Dim Down Stop