Z-Wave ZME WCS1 User manual - page 3
The device can be mounted on every dry and flat surface using either screws or double side adhesive. First
the mounting base is fixed on the wall. Next step the switch frame is placed on the 2 frame and the
electronic insert is used to fix the frame to the mounting base as shown on the image. Finally the switching
paddle(s) are mounted on the electronic base.
For battery change, the switching paddle(s) need to be removed. The CR battery can be replaced by
pushing the little nipple above the battery. The old battery will slide out and the new battery is inserted until
the nipple will hold it again.
The device can be operated in two different modes:
Operation Mode: This is the mode where the device is controlling other Z-Wave devices or is activating
scenes.
Management Mode: The device is turned into the management mode by pushing all four buttons for 5 sec.
A blinking green LED indicates the management mode. In the management mode the buttons of the device
have different functions. If no further action is performed, the device will turn back to the normal mode after
10 sec. Any management action terminates the management mode as well.
In management mode the following actions can be performed:
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 3