Z-World Wildcat BL2000 User Manual - page 15

User’s Manual

11

2.4  PONG.C

You are now ready to test your set-up by running a sample program.

Find the file 

PONG.C

, which is in the Dynamic C 

SAMPLES

 folder. To run the program, 

open it with the 

File

 menu (if it is not still open), compile it using the 

Compile

 menu, and 

then run it by selecting 

Run

 in the 

Run

 menu. The 

STDIO

 window will open and will dis-

play a small square bouncing around in a box.

This program does not test the serial ports, the I/O, or the TCP/IP part of the board, but 

does ensure that the board is basically functional. The sample program described in 

Section 5.3, “Run the PINGME.C Sample Program,” tests the TCP/IP portion of the 

board.

2.5  Where Do I Go From Here?

NOTE:

If you purchased your BL2000 through a distributor or Z-World partner, contact 

the distributor or Z-World partner first for technical support.

If there are any problems at this point:

•

Check the Z-World Technical Bulletin Board at www.zworld.com/support/bb/.

•

Use the Technical Support e-mail form at www.zworld.com/support/support_submit.html.

If the sample program ran fine, you are now ready to go on to explore other BL2000 fea-

tures and develop your own applications.

Chapter 3, “Subsystems,” provides a description of the BL2000’s features, Chapter 4, 

“Software,” describes the Dynamic C software libraries and introduces some sample pro-

grams, and Chapter 5, “Using the TCP/IP Features,” explains the TCP/IP features.