Z-World Wildcat BL2000 User Manual - page 80

76

Wildcat (BL2000)

C.3  Chip Select Circuit

Figure C-5 shows a schematic of the chip select circuit.

Figure C-5.  Chip Select Circuit

The current drain on the battery in a battery-backed circuit must be kept at a minimum.   

When the BL2000 is not powered, the battery keeps the SRAM memory contents and the 

real-time clock (RTC) going. The SRAM has a powerdown mode that greatly reduces 

power consumption. This powerdown mode is activated by raising the chip select (CS) 

signal line. Normally the SRAM requires Vcc to operate. However, only 2 V is required 

for data retention in powerdown mode. Thus, when power is removed from the circuit, the 

battery voltage needs to be provided to both the SRAM power pin and to the CS signal 

line. The CS control circuit accomplishes this task for the SRAM’s chip select signal line.

In a powered-up condition, the CS control circuit must allow the processor’s chip select 

signal /CS1 to control the SRAM’s CS signal /CSRAM. So, with power applied, /CSRAM 

must be the same signal as /CS1, and with power removed, /CSRAM must be held high 

(but only needs to be battery voltage high). Q3 and Q4 are MOSFET transistors with com-

plementary polarity. They are both turned on when power is applied to the circuit. They 

allow the CS signal to pass from the processor to the SRAM so that the processor can peri-

odically access the SRAM. When power is removed from the circuit, the transistors will 

turn off and isolate /CSRAM from the processor. The isolated /CSRAM line has a 100 k

Ω

pullup resistor to VRAM (R101). This pullup resistor keeps /CSRAM at the VRAM volt-

age level (which under no power condition is the backup battery’s regulated voltage at a 

little more than 2 V).

/CS1

/CSRAM

/RESET

Q8

Q4

Q3

R101

VRAM

R104

100 k

W

22 k

W

C81

1 nF