Zadako DRAGON Manual - page 5
5
4. Put the buttom cover on and turn it gently to the right (following the arrows) till the cover suits its right
position. Then connect the power adapter. If the battery is fully charged, red LED light flashes and goes
off, if it isn´t fully charged, red LED light shines permanently (battery is being charged). After full charge of
the battery, red LED light goes off (more information about the battery charging - see page5).
WARNING!
If you insert a prepaid SIM card into the device, you have to check credit on it and its validity because
if there is no credit on the SIM card or the SIM card goes invalid, Mini Alarm stops working!!!
Device supports roaming.
Switching on/off
Switching on: press the button for 3 seconds, till you hear a double beep. When you release the button,
both red and green LED lights start flashing (DRAGON is getting registered to the GSM network). After
appx. 30 seconds red LED light stops flashing, only green LED flashes once for 4 seconds. Mini Alarm is
ready to be used.
Note: If Mini Alarm is connected to the power adapter (battery is being charged), the red LED light shines
at start as well. When the battery is fully charged, red LED light goes off. It may happen that battery is so
low that Mini Alarm doesn´t react on pressing the button and you hear a deep beep. In this situation,
please wait for 5-10 minutes and switch the device on again. You can hear a deep beep after the start of
device as well if there is no SIM card or if the SIM card is inserted in a wrong way or if PIN code isn´t
disabled.
Switching off: press the button for 5 seconds, till you hear a double beep. Both LED lights go off. If you are
charging the battery, red LED light shines also in switched off status. After full recharge of battery, red
LED light goes off.
Battery charging
Mini Alarm is feeded from a power adapter, but in case of need it can work also with an integrated battery.
Fully charged battery can last for up to 5 days. When battery is low, red LED light starts flashing once for
4 seconds, when it is fully discharged, the device switches off. You can charge the battery with supplied
power adapter. After connecting the adapter, Mini Alarm beeps and red LED light starts shining, after
disconnecting the adapter, Mini Alarm beeps again and red LED light goes off. When the charging
process is terminated, red LED light goes off. If you connect the adaper to Mini Alarm even when the
battery is fully charged, device beeps and red LED light flashes once. You can charge the battery only in
positive temperature. Manufacturer recommends to charge the battery before first use.
buttom
cover
SIM holder
battery
jumper