Zadako DRAGON Manual - page 8
8
connector). Device starts to beep permanently, what means that you can release the button because the
settings are already set up. You can disconnect the adapter or leave it connected, up to your needs.
Setting up by text message
You can set up the device by sending a configuration text message (message in which you set up the
parametres) from your mobile phone on telephone number of Mini Alarm. You can set up: telephone
numbers (max. 4), password, leaving time, tapping time by alarm, permission for PANIC mode and texts
of information messages. For a good functionality of device it´s not necessary to set up all these
parametres, the only necessary thing is to set up the telephone numbers. The other parametres can be as
basic settings from factory (see page 7).
You can send a configuration text message also from a number that is not listed in the address book of
Mini Alarm, but you have to apply a correct password. Therefore it´s important to change the password
and give it only to persons that will use the alarm. Text messages with a false password or no password
sent on telephone number of Mini Alarm will be automatically deleted. Calls from unknown telephone
numbers are ignored (people with these numbers can´t tap or disarm)! Numbers listed in address book of
Mini Alarm can´t have CLIR service active when using the device (it can´t recognize the number of calling
person)!
Device signalls the reception of text message (in disarmed status) in the following way:
if the password is correct – green LED light shines (for 2 seconds) and you can hear a high tone,
if the password is false – red LED light shines (for 2 seconds) and you can hear a deep tone /if the
battery is being charged and red LED light shines, reception of text message with a wrong
password is signalled by 2-second extinction of red LED light/.
Rules for writing text messages
Password has to be on the first place, if you want to use „?“ or „$“ as well, they have to be on the
last place.
Watch the gaps (gap is represented by _ ).
You don´t have to differentiate between small and capital letters.
Text of information messages S0- S5 has to be ended by #, telephone numbers not! (See further.)
Examples of configuration message in which you want to set up all parametres:
A/ abcd_H=adam_T1=09xxxxxxxx_T2=09xxxxxxxx_T3=#_T4=#_O=15_L=5_P=ON_?
B/ abcd_S0=dragon#_S1=alarm#_S2=panic#_S3=batt low#_S4=electr off#_S5=electr on#_$
Legend:
abcd
- password of device (4 characters)
_
- gap
H=adam
- changing password from “abcd” to “adam”
T1 T4
- telephone numbers 1-4 (we set up only 2 telephone numbers in our example)
T=#
- telephone number is not set up
O=15
- leaving time 15 seconds (10-120 s)
L=5
- tapping time by alarm or emergency call 5 minutes (0-255 min)
P=ON/OFF
- permission / prohibition for PANIC mode
S0
- name of device / object
S1 S5
- information messages (max. 12 characters), see page 7
Attention! After the return to the factory defaults (reset), all telephone numbers are deleted and it´s
necessary to add the numbers again for further use.