1. DL manuals
  2. Zanussi
  3. Hob
  4. ZGG 642
  5. Instruction Booklet

Zanussi ZGG 642 Instruction Booklet

Manual is about: Zanussi Gas Hobs Instruction Booklet

Summary of ZGG 642

  • Page 1

    Gas hobs zgg 642 zgg 752 instruction booklet please read this instruction booklet before using the appliance gb.

  • Page 2

    2 this appliance complies with the following e.E.C. Directives: * 73/23 - 90/683 (low voltagedirective); * 93/68 (general directives); * 89/336 (electromagnetical compatibility directive); * 90/396 (gas appliances), and subsequent modifications guide to use the instructions the following symbols wil...

  • Page 3

    3 contents for the user for the installer important safety information 2 description of the hob 3 operation 4 maintenance and cleaning 4 something not working? 5 service and spare parts 5 guarantee conditions 6 important safety requirements 10 installation 10 building in 11 electrical connections 12...

  • Page 4

    4 operation hob burners to light a burner: l push in the relevant control and turn it to maximum position; l zgg 752: upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" to be heated and the safety device to be switched off, otherwise the gas supply would be ...

  • Page 5

    5 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Important: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made e...

  • Page 6

    6 zanussi guarantee conditions we, zanussi, undertake that if, within 24 months of the date of the purchase, this zanussi appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same free of any char...

  • Page 7

    7 zanussi service force to contact your local zanussi service force centre telephone 08705 929 929 channel islands guernsey guernsey electricity po box 4 vale, guernsey channel islands jersey jersey electricity company po box 45 queens road st helier jersey channel islands je4 8ny scotland aberdeen ...

  • Page 8

    8 zanussi service force to contact your local zanussi service force centre telephone 08705 929 929 midlands birmingham 66 birch road east (m18) wyrley road ind. Estate witton birmingham b6 6db bourne manning road ind. Estate (m44) pinfold road bourne pe10 9ht bridgnorth 68 st. Mary’s street (m72) br...

  • Page 9

    9 overall dimensions zgg 642 zgg 752 width: 580 mm. 680 mm. Depth: 510 mm. 510 mm. Cut out dimensions zgg 642 zgg 752 width: 550 mm. 560 mm. Depth: 470 mm. 480 mm. Supply connections gas: rc 1/2 inch (1/2 inch male) rear right hand corner electric: 230-240v 50hz supply, 3 core flexible cable with no...

  • Page 10

    10 a) end of shaft with nut b) washer c) elbow fo 0814 fo 0264 fitting the gas hob without a cooker hood above fitting the gas hob with a cooker hood above 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm fo 2369* fo 2231* important safety req...

  • Page 11

    11 building in cut out size the dimensions of the cut-out are given in the diagram. 550 470 55 min. 30 rectangular cut-out size for hob dimensions are given in mm. 560 150 min 480 55 min. Fo 2038 fo 2098 zgg 642 zgg 752 on/off switch flex outlet on/off switch flex outlet fo 0763 fo 0764 1 2 dimensio...

  • Page 12

    12 f electrical connections any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This hob must be earthed. The manufacturer declines any liability should these safety measures not be observe...

  • Page 13

    13 a. Ignitor switch b. Ignitor unit b l n 0 1 2 3 4 5 6 220/240 a wiring diagram fault finding preliminary electrical systems check a. Earth continuity check - appliance must be electrically disconnected - meter set on w (ohms) x 1 scale and adjust zero if necessary. A) test leads from any applianc...

  • Page 14

    14 ignition system / gas ignition yes check plug top fuse and replace if necessary check polarity and earth continuity of supply point check earth continuity of appliance ignitor does not spark check fitting of burners check position of the electrode check by pass simmer adjusted light burner manual...

  • Page 15

    15 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...

  • Page 16

    Customer care zanussi 55-77 high street slough berkshire, sl1 1dz tel: 08705 727727 © electrolux household appliances limited 2000 grafiche mdm - forlì 35668-9202 08/00 from the electrolux group. The world’s no.1 choice. The electrolux group is the world’s largest producer of powered appliances for ...