- DL manuals
- Zanussi
- Hob
- ZGG 642
- Instruction Booklet
Zanussi ZGG 642 Instruction Booklet
Summary of ZGG 642
Page 1
Gas hob zgg 642 instruction booklet please read this instruction booklet before using the appliance gb.
Page 2: Important Safety Information
2 important safety information you must read these warnings carefully before installing or using the hob. If you need assistance, contact our customer care department on 08705 727 727. Installation • this appliance must be installed and serviced by a competent person as stated in the gas safety (ins...
Page 3: Contents
3 contents keep this instruction book for future reference and ensure it is passed on to any new owner. For the user important safety information 2 description of the hob 4 operation 5 maintenance and cleaning 5 something not working? 6 guarantee/customer service 15 european guarantee 16 environment...
Page 4: Description of The Hob
4 description of the hob 1. Semi-rapid burners 2. Rapid burner 3. Auxiliary burner 4. Control knobs 2 1 3 1 4.
Page 5: Operation
5 operation hob burners to light a burner: z push in the relevant control and turn it to maximum position; z then adjust the flame as required. Z if the burner does not ignite, turn the control knob to zero, and try again. If you use a saucepan which is smaller than the recommended size, the flame w...
Page 6: Something Not Working?
6 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Important : if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made ...
Page 7: Engineers Technical Data
7 overall dimensions width: 580 mm. Depth: 510 mm. Cut out dimensions width: 550 mm. Depth: 470 mm. Supply connections gas: rc 1/2 inch (1/2 inch male) rear right hand corner electric: 230 v 50 hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse. Burner dia. ...
Page 8: Location
8 important safety requirements this hob must be installed in accordance with the gas safety (installation and use) regulations (current edition) and the iee wiring regulations (current edition). Detailed recommendations are contained in the following british standards codes of practice: b.S. 6172/ ...
Page 9: Installation
9 a) end of shaft with nut b) washer c) elbow fo 0814 fo 0264 installation important this hob must be installed by a competent and qualified person only. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ign...
Page 10: Building In
10 building in dimensions are given in mm. Building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical...
Page 11: Electrical Connections
11 ) electrical connections any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This hob must be earthed. The manufacturer declines any liability should these safety measures not be observe...
Page 12: Wiring Diagram
12 a. Ignitor switch b. Ignitor unit b l n 0 1 2 3 4 5 6 220/240 a wiring diagram fault finding preliminary electrical systems check a. Earth continuity check - appliance must be electrically disconnected - meter set on Ω (ohms) x 1 scale and adjust zero if necessary. A) test leads from any applianc...
Page 13
13 ignition system / gas ignition yes check plug top fuse and replace if necessary check polarity and earth continuity of supply point check earth continuity of appliance ignitor does not spark check fitting of burners check position of the electrode check by pass simmer adjusted light burner manual...
Page 14: Commissioning
14 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...
Page 15: Guarantee/customer Service
15 guarantee/customer service standard guarantee conditions we, zanussi-electrolux, undertake that if within 12 months of the date of the purchase this zanussi-electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option...
Page 16: European Guarantee
16 this appliance is guaranteed by electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move w...
Page 17
17.
Page 18
18.
Page 19
19.
Page 20
35690-0402 11/06 grafiche mdm - forlì www.Zanussi-electrolux.Co.Uk.