Zanussi ZOP38903XD User Manual - What to Do If…
1 2
3
Make sure that you put the glass panels (1, 2
and 3) back in the correct sequence. The mid-
dle panel (2) has a decorative frame. The
screen-printing zone must face the inner side
of the door. Make sure that after the installation
the surface of the glass panel frame (2) on the
screen-printing zones is not rough when you
touch it.
Make sure that you install the top panel in the
seats correctly.
What to do if…
Warning! Refer to the Safety chapters.
Problem
Possible cause
Remedy
The oven does not heat up.
The appliance is deactivated.
Activate the appliance.
The oven does not heat up.
The clock is not set.
Set the clock.
The oven does not heat up.
The necessary settings are not
set.
Make sure that the settings are cor-
rect.
The oven does not heat up.
The automatic switch-off is on.
Refer to "Automatic switch-off".
The oven does not heat up.
The Child Lock is on.
Refer to "Deactivating the Child Lock".
The oven does not heat up.
The fuse in the fuse box is re-
leased.
Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician.
The oven lamp does not oper-
ate.
The oven lamp is defective.
Replace the oven lamp.
The oven does not heat up.
The fan does not operate. The
display shows
or
.
The demo mode is activated.
1.
Deactivate the appliance.
2.
Press and hold the button
for
approximately two seconds. An
acoustic signal sounds.
3.
Press and hold the buttons
and
at the same time until the
acoustic signal sounds again and
the indicator goes out.
20
www.zanussi.com