Zanussi ZT 6810 Instruction Booklet - Filling With Salt

Filling with salt

If your water is "level 0" it is already soft and therefore

there is no need to use salt.

Salt must be used from "level 1" upward. 

Only use salt specifically designed for 

use in dishwashers.

All other types of salt not specifically 

designed for use in dishwasher, 

especially table salt, will damage the 

water softener.

Only fill with salt just before starting one of the

complete washing programmes (not the Rinse and Hold

programme). This will prevent any grains of salt or salty

water, which may have been spilled, remaining on the

bottom of the machine for any period of time, which

may cause corrosion.

To fill:

1.

To fill with salt, unscrew the cap of the salt 

container.

2.

Pour about 1 litre of water inside the container,

or until it is full (this is necessary only before 

filling with salt for the first time).

3.

Then using the funnel provided, pour in the salt 

until the container is full (approx. 2 kg).

Do not worry if water over flows from the unit 

when filling with salt, this is quite normal.

4.

Replace the cap making sure that there is no 

trace of salt on the screw thread or on the 

gasket.

5.

Screw on the cap tightly.

The salt container will require topping up periodically. 

You are reminded of this by the "Salt refill indicator

light" on the control panel which comes on when the salt

has finished (if level 0 has been selected, the indicator

light will always be on).

The "Salt refill indicator light" on the

control panel can remain illuminated

for 2-6 hours after the salt has been

replenished, assuming the dishwasher

remains switched on. If you are using

salts that take longer to dissolve then

this can take longer. The function of

the machine is not affected.

8

PFS08UK

SAL

T

SR07