Zapco ZX-series Owner's Manual - page 8
GND
B+
GND
GND
REM
B+
B+
POWER INPUT B
POWER INPUT A
POWER INPUT C
B+
GND
GND
GND
REM
B+
B+
POWER INPUT E
POWER INPUT D
POWER INPUT F
To +12V DC
250A x 6 (External Type Fuse)
Recommended Ampere
to REMOTE Turn-on
from HEAD UNIT
HEAD UNIT
To +12V DC
To +12V DC
ZX-26KD
First make the ground connection, then +12V wire connection, and finally the remote
connection. Furthermore, the +12V wire must always be fused at the battery for protection
against possible damage. If you need to replace the power fuse, replace it with a fuse of
the same value. It may result in a serious hazard to use a fuse of a different type or rating.
Caution
+12V Power
Connect the +12V terminal of the amplifier to the + terminal of the battery using the same diameters
the power and ground cables, making sure you install in-line fuse holders, approximately 12" from
the + terminal of battery, making sure that there is no fuse in the battery holder.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars chassis.
Keep this cable as short as possible (not longer than 500 mm. or less).
This connection MUST be made at the frame and be rust free and clear of paint or grime.
REMOTE
Connect the REM terminal of the amplifier to the =12 Trigger out of the source unit, or an accessory
terminal at the fuse box or ignition switch.
BATTERY
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
POWER CONNECTION
-4-