Zartek CDP-801 Instruction Manual

Summary of CDP-801

  • Page 1

    2 overview: the zartek digital wireless intercom is our third generation system newly developed following six years of r&d. It is fully approved by icasa. Applications for this system include houses, offices, cottages, security access points this system is well suited for self installation. The gate...

  • Page 2

    4 3 1. The supplied li polymer battery pack is already installed in the handset. To replace, press down the lock button 16 and slide open the battery door, take out the battery pack and disconnect from socket 18 . 2. Keep the handset switched off and place it into the charger stand. 3. Plug in the s...

  • Page 3

    1. Place the caller unit and handset close to each other within a distance of 1m. 2. With the handset in switch off mode, press and hold power on/off button 12 and door lock open button 13 together for around 3 sec to enter pairing mode. The lcd will become backlighted and show a flashing letter “ ”...

  • Page 4

    8 7 always close these two terminals normally provide a 12v supply. During communication, once the door lock opening button 13 is pressed, this voltage will drop to 0v temporarily for 3 seconds. Always open these two terminals normally provide 0v. During communication, once the door lock opening but...

  • Page 5

    Detailed operation powering handset switch on the handset by a long press (over 3 seconds) of the power on/off button 12 . Press the same button again in case you want to switch off the unit. The lcd screen will show up. In case the self battery low icon o appears and an alarm heard, the battery has...

  • Page 6

    Answering call upon receiving a call, either icon a or icon b appears on the screen, depending the call is from the front gate or back gate (in case you have purchased an optional caller unit for back gate). The handset can answer the call by pressing the answer button 11 and the reception mode icon...

  • Page 7

    14 13 intercommunication between handsets this function is applicable only if you have two or more handsets. Please note all units must be paired together. A. Under standby mode, momentarily press answer button 11 , a “do – do” sound will be heard. B. The called handset will show the selected incomi...