Zartek CDP-801 Instruction Manual - page 5
Detailed Operation
Powering Handset
Switch on the handset by a long press (over 3 seconds) of the Power ON/OFF button 12 .
Press the same button again in case you want to switch off the unit.
The LCD screen will show up. In case the self battery low icon O appears and an alarm heard,
the battery has run down and needs to be recharged by placing the unit into the charger stand.
During charging, the segments inside the battery level icon P will flash in turn irrespective the unit
is switched on or off. To protect battery, if the unit is not being re-charged when the icon O shown
up, it will be switched off automatically after 10 minutes.
Setting Ring Type
To select the different methods of incoming call alert, press and hold the Volume Up/Down buttons 9
& 10 simultaneously for 2 sec to enter the selection mode. Use the Volume Up 9 or Down
button 10 to choose one of the seven alert methods, shortly press the Hang up button 12 to
confirm your selection and return to normal operation mode.
Depending on your selection, either one of the icons F to L will be shown on the screen. Note that
in case you select a combination with vibrating alert, the battery will run down more easily.
Setting Audio Volume
During conversation, the sound volume heard through the speaker 17 can also be adjusted using
buttons 9 & 10 and the speaker volume icon Q will change correspondingly. Please
note the loudness of door chime is fixed and cannot be adjusted.
Gatestation Ring Functions
Make sure there is power supply to the caller unit (either by 12V DC or alkaline batteries). Now
press the Call button 1 , a ding-dong tone will be heard and the Call indicator 4 starts
flashing. Until a handset answers the call, the ding-dong tone will be heard periodically, reminding
the visitor to keep waiting. In case there is no answer after 20 seconds, the caller unit ends the call
by itself and the Call indicator 4 goes off. Press the Call button 1 to initiate the call again.
N.B. In case there are two caller units (frontgate and backgate), only the unit whose call botton
1 is first pressed will send out a call signal to handset, the remaining unit will keep in
standby mode until the conversation is over. If its call button 1 is pressed during this period,
a two “Be-Be” sound will be heard and the call indicator 4 flashes for two times, indicating the
unit is under standby mode.
Once the call is being answered, the Call indicator 4 will light up steady and the ding-dong tone
stops ringing. Conversation can now be conducted by speaking into the Microphone 2 .
10
9
Frontgate doorbell ringing
Backgate doorbell ringing
Missed call
F (Frontgate)
B (Backgate)
Reception mode
Out of range alert
F (Frontgate)
B (Backgate)
Door chime alert selected
Flashing light alert selected
Vibrating alert selected
Door chime and
flashing light alert selected
LCD
J
K
L
M
N
O
P
Q
R
A
B
C
D
E
F
G
H
I
Door chime and
vibrating alert selected
Flashing light and
vibrating alert selected
Door chime, flashing light and
vibrating alert selected
Door lock opened
Caller unit battery low
F (Frontgate)
B (Backgate)
Self battery low
Battery level
Speaker volume
Door lock de-activated
Flashing
Steady light up
Outdoor
temperature
Battery Level
Speaker volume
Door chime, flashing
light and vibrating
alert selected
Door lock de-activated
Missed call
Reception mode
Frontgate &
Backgate
doorbell ringing
Door lock
opened
Caller unit battery low
Basic Operation
HANDSET
RINGS &
ANSWERED
RESIDENT
PRESSES
TO SPEAK
RESIDENT
OPENS
GATE
VISITOR
SPEAKS
VISITOR
PRESSES