Zavio S5040 Quick Installation Manual - page 7
6
First-time use – install wizard
When the first time connect IP cameras to the NVR, the NVR will pop up install wizard
window.
Full Auto Install Mode
Click “Full Auto Install” and then the NVR will automatically configure IP address of a camera
connected by LAN. The NVR will then detect the IP camera and display image on screen.
Note:
1. This mode is suitable when the LAN is connected to a hub.
2. User also can go to Configuration→System→Device→Install Wizard, to bring up the Install
Wizard. If the NVR does not configure the IP camera automatically, please recheck the
conditions as listed above and rerun the Install Wizard when it’s ready.
Manual Install Mode
If user would like to add IP camera manually in wizard, please follow the below steps.
Step 1. Click “Manual Install” and press “Next’ to the next page.