Zaxcom ZFR800 Owner's Manual - page 7
ZFR800 Handheld Recording Microphone Owner’s Manual
Chapter 1
3
Getting To Know Your ZFR800
Record Button
The record button is located farthest from the display and has a circular symbol. This is button is
indicated by the 1 in the above figure.
The record key on the ZFR800 is used to put the unit in record mode, stop mode, and to mark files.
When the ZFR800 is in stop mode, pressing the record key places the unit in the record mode. A
single beep tone from the headphone monitor indicates the ZFR800 is now in the record mode.
When in the record mode, pressing and holding the record button for two seconds stops the
recording. A dual beep tone from the headphone monitor indicates the ZFR800 is no longer
recording and is in the stop mode.
When in the record mode, pressing the record key for one second or less places a track marker on
the audio. This enables the post production staff to easily find that specific location in the audio
file. Three beep tones from the headphone monitor indicates a track marker has been placed on the
audio track.
NOTE:
Audio beeps are not placed on the actual audio track.
Menu Button
The menu button on the ZFR800, indicated by the 2 in the above figure, is a square symbol.
Pressing this button brings up the ZFR800 options.
Turning the ZFR800 On and Off
A power switch is located in the battery compartment near the positive battery contact. To operate
the power switch, the battery door must be opened.
6
7
1. Record button
2. Menu button
3. Increment button
4. Decrement button
5. LCD screen
6. MiniSD slot
7. Headphone jack