ZBoost ZB560Y Manual - page 14
zBoost
®
Cellular REACH ZB560Y Manual
7
snapping the Base Unit back in place keeping the Indoor Antenna vertical. The Base Unit uses an
omni-directional Indoor Antenna that delivers signal in a circular pattern around the antenna.
The zBoost Cellular REACH requires at least 15 feet of vertical separation between the Base
Unit and the External Antenna. Generally, increasing this distance (up to 40 feet) will increase the
performance and decreasing the distance will limit the performance.
Keep the Base Unit off the floor and at least 2 feet away from other cords, metal objects or other
wireless devices such as wireless routers or wireless access points. The zBoost Cellular REACH
performs best when there are no obstructions between the zBoost Base Unit and your mobile
device.
THIRD: Run the Coaxial Cable
NOTE: Refrain from securing cable or drilling holes until the system has been tested.
Connect the supplied 50 feet of RG-6 coaxial cable to the base of the External Antenna. Run the
coaxial cable along a descending pipe or through a wall that leads closest to the location of the
Base Unit. Should you need additional cable length, 15 foot extensions (Part #:
YX030-15w) are
available at www.zBoost.com. Please note: Cable longer than 65 feet is not recommended.
FOURTH: Connect zBoost Base Unit to Power
Connect the zBoost Base Unit to the power supply and plug into a power outlet. When your
zBoost system is in place and fully connected, walk
throughout your home and verify that you are able
to reliably place calls. If the signal strength has
improved, your zBoost is working.
Upon initial power up, the LED will cycle RED,
GREEN and ORANGE for 30 seconds. After 30
seconds, a series of GREEN flashes will indicate
the quality of your setup. Following this, a solid
GREEN light indicates normal conditions. If it is not
solid GREEN, follow the instructions in the Base Unit
LED Indicators section. Adjustments may be needed
to optimize performance. If you find the increased
signal coverage is acceptable, however, no additional
adjustments are needed. See “zBoost Base Unit Light
Indicators” on page 10) for more information.
Antenna Aiming
To get the maximum benefit, you will want to take special care to make sure you point the antenna
in the direction of the best signal for your wireless service provider. You may wish to use a YX699
RF signal meter to help during this process or try our zBoost Signal Finder Android App. The
majority of the time a cell tower will hold more than 1 frequency band and/or service provider.
To aim the antenna for maximum signal, you will need a phone operating on the same wireless
network(s) in use at the install location.
Note: A 1 dBm increase is 25% gain in signal strength.
If you do not know which direction the best signal is coming from, once the unit is installed, rotate
the External Antenna in 90 degree increments while measuring the results inside the desired
coverage area.
Place the cell phone(s) on a non-metal surface about 6-8 feet from the Base Unit.
zBoost Base Unit
Power Supply
Base Unit Antenna
Coaxial Cable
Base Unit Bracket