ZDC ZN-7100-DE500-G Quick Setup Manual - page 3
STEP 5: INSTALL THE AP
1. Disconnect the AP’s power adapter from the
power outlet (or disconnect the PoE cable).
2. Move the AP to its permanent location
(accessible to both power source and
network connections).
Note:
Make sure that sufficient survey has been made
to determine the best placement for maximum
range, coverage, and network performance
before installing.
STEP 6: WATERPROFFING THE CABLE
For outdoor installation, you need to waterproof the
LAN port using the supplied sealing cap.
1. Slide the locking nut over the bare end of
the Ethernet cable.
2. Slide the sealing cap over the bare end of
the Ethernet cable.
3. Terminate the Ethernet cable with a
standard RJ-45 connector.
4. Connect the RJ-45 connector into the
wireless AP LAN port.
5. Flush the locking nut together into the
LAN port opening, then twist the locking
nut to seal the opening.
6. Tighten the sealing cap.
MOUNTING ON A POLE
1. Secure the mounting clip to the back of
the wireless AP with four screws.
2. Slide the securing rings through the
mounting bracket. Adjust the straps to
make sure that the rings are securely
fastened to the pole.
3. Slide the mounting clip into the slot on
the mounting bracket.
4. Insert the bolt into the hole on the
mounting clip the mounting bracket, and
secure the end with the lock nut.
Note:
Make sure that the pole for installation is securely
attached to a solid, stable base.
Note:
Do not tighten the lock nut completely at this
time, as you may need to make adjustments to
obtain good signal strength.
INSTALLING THE ANTENNA (OPTIONAL)
You may install optional 5GHz antennas on top
of the Access Point to extend the range of
your wireless network.
Cautions:
1. Make sure that you disconnect the Smart
Access Point from the power source before
connecting the optional antennas
2. Do not remove the metal caps if you are not
installing 5GHz antennas
1. Unscrew the metal caps protecting the
antenna connectors.
2. Connect the 5GHz antennas to the standard
N-type female antenna connectors on the
AP.