Zebex Barcode scanner Quick Referenc Manual - Cradle Host Mode
Start Of Configuration
Cradle Host Mode
1.
Connect the cradle and the computer. Please make sure the cradle LED is flashing
blue indicating it’s not linked to any scanner. If the LED shows steady blue, the
cradle is already paired to another scanner so you must unpair the scanner before
continuing.
2.
Power on the scanner and enable cradle host mode if necessary. To enable Cradle
Host mode, scan the following barcodes: Start Of Configuration, Cradle Host mode
enable, then End Of Configuration.
Cradle Host mode enable
3.
Use the scanner to scan the pairing barcode at the bottom of the cradle to begin
pairing. 3 short beeps will be heard.
4.
The LED indicator on the scanner will flash blue rapidly indicating search mode in
process. The LED on the cradle becomes steady blue when the pairing is successful.
5.
Scan the label of the corresponding host interface the cradle is using in System
Settings to begin using the scanner.
23
End Of Configuration