Zebex Barcode scanner Quick Referenc Manual - Spp Master Mode

Start Of Configuration 

SPP Master Mode 

1. 

Power on of the remote device and have its address ready in hand. Please also 

make it discoverable. 

2. 

Program the scanner with the “SPP Master enable” barcode.   

Scanner SPP Master enable 

3. 

Scan “Set wireless address” to set the address. 

Set wireless address (SPP Master only)

4. 

Use the ASCII table in Programming Guide to input the 12 digit wireless address. 

For example: if the address is “011B1345600”, scan “0”, “0”, “1”, “1”, “B”, “1”, “3”, 

“4”, “5”, “6”, “0”, “0” from ASCII barcode labels. 

5. 

Scan “Confirm Setting” to store the address. 

Confirm Setting (for address and pin code setting 

required) 

6. 

Setup and input the pin code if necessary. Please see Setting Pin Code section for 

more details. 

7. 

Scan “Required Pair with slave (SPP Master)” to begin pairing. 

Required Pair with slave (SPP Master)

25

End Of Configuration