Zebex Z-3051BT User Manual - Connecting The Cradle

Handheld Bluetooth® CCD/Laser Scanner 

6 

U

SER

’

S 

M

ANUAL

Once the scanner is well situated in the cradle, press down any one of the small buttons 

at the side of cradle

LED lamp to start charging (Shown as Figure). 

Figure 2-7    Press any one to start charging 

The LED of scanner light in RED as in charge, and light in BLUE when full charged. Refer to 

Chapter 9 for LED indication. 

We call this “Smart Charge”, as battery life is well depended on the charging number of 

times, so only charge the batteries when necessary by following the abovementioned 

procedures to prolong your battery life. 

You may also set up auto-charging as every time the scanner is placed into the cradle.   

Follow and scan the appropriate barcode symbols to set up from programming section of 

this booklet 

Note: 

  For first charging, always charge the batteries over 5 hours continuously to 

prolong your battery life. 

  After every full charge, you may use the scanner for 8 hours continuously. 

  Recommended charging environment is temperature in 0°C~35°C (32°F~95°F). 

Connecting the Cradle 

There are two types of cradle to select for this scanner. 

Charging Cradle 

Cradle Host 

Charging Cradle 

This cradle designs for battery charging only, it does not support radio communication.   

Simply connect the external DC-9V9W power adapter into it and place scanner into 

cradle to start charging. 

When charging is not required, it is recommended to remove the adapter plug to retain 

the battery life. 

Cradle Host 

The cradle host features with advanced wireless technology and designs to support radio 

communication to the scanner.  It the same has charging functionality.  Refer to 

Charging Batteries section for battery charging instructions.