Zebex Z-3051BT User Manual - Radio Notice

Handheld Bluetooth® CCD/Laser Scanner 

iii 

Radio Notice 

This equipment generates uses and can radiate radio frequency energy.    If not installed 

and used in accordance with the instructions in this manual, it may cause interference to 

radio communications.    The equipment has been tested and found to comply with the 

limits for a Class A computing device pursuant to EN55022 and 47 CFR, Part 2 and Part 15 

of the FCC rules.    These specifications are designed to provide reasonable protection 

against interference when operated in a commercial environment. 

Radio and Television Interference 

Operation of this equipment in a residential area can cause interference to radio or 

television reception.  This can be determined by turning the equipment off and on.  

The user is encouraged to try to correct the interference by one or more of the following 

measures: 

- Reorient the receiving antenna. 

- Relocate the device with respect to the receiver. 

- Move the device away from the receiver. 

- Plug the device into a different outlet so that the device and the receiver are on 

different branch circuits. 

If necessary the user may consult the manufacturer, and authorized dealer, or 

experienced radio/television technician for additional suggestions.    The user may find 

the following booklet prepared by the Federal Communications Commission helpful: 

“How to Identify and Resolve Radio-TV Interference Problems.”    This booklet is available 

from the U.S. Government Printing Office, Washington, DC 20402 U.S.A., Stock No. 

004000003454. 

Laser Safety 

This equipment generates, uses, and can radiate radio frequency energy. If not installed 

and used in accordance with the instructions in this manual, it may cause interference to 

radio communications. The equipment has been tested and found to comply with the 

limits for a Class A computing device pursuant to EN55022 and 47 CFR, Part 2 and Part 15 

of FCC Rules. These specifications are designed to provide reasonable protection against 

interference when operated in a commercial environment. 

Radiant Energy: The laser scanner uses one low-power visible laser diodes operating at 

650nm in an opto-mechanical scanner resulting in less than 3.9μW radiated power as 

observed through a 7mm aperture and averaged over 10 seconds. 

Do not attempt to remove the protective housing of the scanner, as unscanned laser light 

with a peak output up to 0.8mW would be accessible inside.