Zebra FLB3508 Quick Reference Manual - Cradle Connections
6
FLB3508/3578 Cradle
Cradle Connections
IMPORTANT
Connect the interface cable and power supply (if necessary) in the
following order to ensure proper operation of the scanner and cradle.
1.
Insert the interface cable from the host computer into the cradle’s host port.
2.
Connect the forklift power supply to the
cradle’s power port, if applicable.
3.
Optional: Thread the host cable over the
cable hook and run the host and power
cables into their respective cable grooves, or
use cable ties to secure them to the
mounting plate after it is attached to the
cradle (see
).
4.
Pair the scanner with the cradle by
scanning the pairing bar code on the cradle.
5.
If necessary, scan the appropriate host bar
code (for non-autodetected interfaces). See
the
Product Reference Guide
.
Changing the Host Interface
To connect to a different host, or to the same
host through a different cable:
1.
Unplug the power supply from the cradle, if
used.
2.
Unplug the interface cable from the host.
3.
Connect the interface cable to the new
host, or the new interface cable to the
existing host.
4.
Reconnect the power supply, if required.
5.
If necessary, scan the appropriate host bar code (for non-autodetected interfaces).
Refer to the
Product Reference Guide.
CAUTION
If the scanner does not recognize the host, disconnect the power supply,
then reconnect after connecting the host cable.
Host
Port
Power Port