Zebra FLB3508 Quick Reference Manual - Reach Envelope
Quick Reference Guide
7
Mounting the Cradle on the Forklift
1.
Consult an environmental health and safety
manager to determine
an appropriate mounting location within the
recommended 15" reach envelope.
2.
Ensure the converter knob is in the correct
position (see
Caution
in
section).
3.
Attach the host and power cables to the
appropriate ports (see
).
4.
Position the cradle with the screw holes in the
cradle aligning with the holes in the isolators.
5.
Attach the cradle to the bracket using three
8-32 x 1.5" Philips screws through the cradle
and isolator holes.
6.
Mark the mounting surface through the four
screw holes on the mounting bracket, or use
the mounting template to determine the
location of the screw holes.
7.
Pre-drill holes into the mounting surface to
accommodate four 1/4-20, minimum 1.0"
length, Philips head screws.
8.
If desired, thread cable ties through the holes
on each side of the bracket and secure the
host and power cables along the edges of the
bracket.
9.
Attach the bracket to the mounting surface.
10.
Place the scanner in the cradle.
15" Radius
Side View, Standing
Top View
Side View, Seated
Reach Envelope
15" Radius
15" Radius