Zebra LI3678 Quick Start Manual - page 15
LI3678 Quick Start Guide
15
Laser Devices
Class 2 laser scanners use a low power, visible light diode. As with any very bright light source such as the sun, the
user should avoid staring directly into the light beam. Momentary exposure to a Class 2 laser is not known to be
harmful.
The following statement is required to comply with US and international regulations.
Scanner Labels
Scanner labels read:
• LASER LIGHT - DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT.
• COMPLIES WITH 21 CFR1040.10 AND 1040.11 EXCEPT FOR DEVIATIONS PURSUANT TO LASER NOTICE
NO. 50, DATED JUNE 24, 2007, AND IEC 60825-1 (Ed.2.0), EN60825-1:2007.
LED Devices
For LED devices which have been evaluated to IEC 62471 and comply with the Exempt Risk Group, no product
labeling requirements apply. However, the following statement is required to comply with US and international
regulations:
LED Compliance Statement:
Classified as 'EXEMPT RISK GROUP' according to IEC 62471:2006 and EN
62471:2008. Pulse duration: Continuous mS.
Scanner Labeling
Batteries
Taiwan - Recycling
EPA (Environmental Protection Administration) requires dry battery producing or importing firms in accordance with
Article 15 of the Waste Disposal Act are required to indicate the recycling marks on the batteries used in sales,
giveaway, or promotion. Contact a qualified Taiwanese recycler for proper battery disposal.
Battery Information
Use only Zebra approved batteries. Accessories which have battery charging capability are approved for use with the
following battery models: Part Number 82-166537-01 (3.6 Vdc, 3200 mAh).
Zebra approved rechargeable battery packs are designed and constructed to the highest standards within the industry.
CAUTION
Use of controls, adjustments, or the performance of procedures other than those specified
herein may result in hazardous laser light exposure.
CAUTION
Risk of explosion if battery is replaced by an incorrect type. Dispose of batteries according
to instructions.
LASER LIGHT- DO NOT STARE
INTO BEAM CLASS 2 LASER
PRODUCT
COMPLIES WITH 21 CFR1040.10 AND
1040.11 EXCEPT FOR DEVIATIONS
PURSUANT TO LASER NOTICE NO. 50,
DATED JUNE 24, 2007, AND IEC 60825-1
(Ed 2.0), EN60825-1:2007.