ZeeVee ZyPerMX User Manual - page 11
16
17
Basic Operation
► Using the
reset button
1. Locate the
reset button on the rear panel of the unit, next to the POWER receptacle.
The button is recessed to prevent the unit from being accidentally reset.
2. Press and hold the reset button, using the end of a paperclip or other pointed object.
Wait approximately 5-10 seconds, then release the button.
3. After about 60 seconds, the unit will be ready for use.
Rebooting the ZyPerMX
The ZyPerMX can be rebooted using Maestro Rebooting the unit does not reset the
ZyPerMX to factory-default settings.
1. Login to the Maestro web interface. See
The Maestro Web Interface (page 4)
for
more information.
2. Click the
Device tab.
3. Click the
Reboot button, under Actions.
High Performance
Video Encoder
IP Streaming Output
ZyPerMX
POWER
STATUS
High Performance
Video Encoder
IP Streaming Output
ZyPerMX
POWER
MEDIA INPUT
HDMI In
up to 1080p
+12VDC 1.0A
reset
Ethernet (POE)
10/100/1000
TRANSPORT
reset button
Basic Operation
Setting the Password
The default login password for the Maestro web interface is
admin. This password can
be changed using the following procedure. To recover a lost or forgotten password, see
Recovering a Lost Password (page 18)
.
1. Login to the Maestro web interface. See
The Maestro Web Interface (page 4)
for
more information.
2. Click the
Device tab.
3. Click the
Password button, under Actions.
4. Enter the new password in the top field, then retype the password in the bottom field.
All passwords must be 4 to 16 characters in length and are restricted to alphanumeric
(letters and numbers) characters.
5. Click the
OK button to accept the changes. Click the Cancel button to return to the
Device tab without any changes.