Zeiss Stemi 508 Operating Manual - page 21
Stereo microscope
INSTALLATION
ZEISS
Stemi 508
General information
06/2015
435064-7044-010
19
Engl
is
h
3
INSTALLATION
3.1
General information
Before installing and commissioning the device, make sure to read the
carefully (see Section
The Stemi 508 with the necessary tools and optional equipment is delivered in several standard packages.
•
Take all units out of the packaging and check them for completeness according to the delivery note.
For installation and/or transport of the microscope or the stand, exclusively use the handle
(Fig. 3/5) provided to this effect.
•
Remove transport securing devices (adhesive tapes etc.).
•
Keep original packaging for a possibly extended period of storage or return of the device to the
manufacturer or dispose of it appropriately.
3.2
Installing the stereo microscope
•
Place stand (Fig. 7/3) on a level, firm support.
•
If the Stemi 508 body (Fig. 7/2) has not yet
been mounted, insert it in the Stemi mount
(Fig. 7/4), align it and secure it using the
clamping screw (Fig. 7/5).
The appropriate Allen key (Fig. 7/8) is located in
the support on the back of the device.
•
If the two eyepieces (Fig. 7/1) have not yet been
mounted, insert them both to their stop in the
eyepiece tube.
•
Remove the two caps (Fig. 6/1) from the
eyepieces.
•
Remove the cap (Fig. 6/2) from the specimen by
turning it.
Fig. 6
Removing caps