Zeiss Stemi 508 Operating Manual - page 22
ZEISS
INSTALLATION
Stereo microscope
Installing the stereo microscope
Stemi 508
20
435064-7044-010
06/2015
Engl
ish
•
Insert glass plate or B/W plastic plate (Fig. 7/6)
in the mount in the base of the stand. To this
effect, press the glass plate or the B/W plastic
plate against the spring (Fig. 7/7) and make it
lock in.
Installation of a reflected-light
illuminator has been described in
Section
If necessary, the ease of motion of the
focusing drive can be set as required on
a case-by-case basis by adjusting the
two focusing knobs (Fig. 8/1 and 2) in
opposite directions.
The ease of motion must not be set so
loosely that the drive moves
downwards by itself. This might
damage the microscope or the
specimen.
Fig. 7
Installing the stereo microscope
Fig. 8
Setting the ease of motion of the
focusing drive