Zektor HDMI5 User Manual - page 11
1
HDMI5 Component Video Switch
1
HDMI5 Component Video Switch
1 2 3 4 5 SEL A1 A2
Step 1: Set the HDMI5 to the preferred initial power on state
Setup the HDMI5 to the initial power on
state you’d prefer. In this case we want the
HDMI5 to turn on and switch to Input 5
when first plugged in.
Step 2: Save the new initial power on state
1 2 3 4 5 SEL A1 A2
Start by pressing and
holding the Power
button...
Setting the Initial Power On State
As long as the HDMI5 is plugged in, it will remember the previously
selected input in standby mode. When powered up by pressing the
Power button, it will return to that previously selected channel.
However, if power is removed (for instance a plug strip used to
power the HDMI5 is turned off ), and then re -applied, the HDMI5’s
default behavior is to enter into the standby mode.
I t is possible to change the power on behavior of the HDMI5.
To change the power on defaults...
Step 1: Setup the HDMI5 to your preferred power on state
.
Use the front panel buttons to setup the HDMI5 to the op -
erating settings you’d like at initial power up.
Step 2: Save the new initial power on state.
First press and hold the Power button.
While continuing to hold the Power button, press and hold
the ‘1’ button.
After holding both buttons for about ‘’ seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
You can test the new defaults by either disconnecting the
power supply from the back of the HDMI5 or by unplugging
the power supply from the wall.
Reconnect power. The HDMI5 will power up into your new
power on default state.
•
1.
2.
3.
•
•
1
2
...while continuing to hold the Power
button, press and hold the ‘1’ button.
After about seconds, the display will
flash indicating the new power on state
has been accepted.
3