Zektor HDMI5 User Manual - Instructions (Cont'D)
6
HDMI5 Component Video Switch
7
HDMI5 Component Video Switch
Instructions (Cont'd)
Auxiliary Relay Connections
The auxiliar y relay contacts are rated for 0volts @ 5amps,
A.C. or D.C., and can be used to switch on and off anything
you can think of within those limits.
Each relay has a Normally Open connection, two Common
connections, and a Normally Closed connection.
The diagram to the left demonstrates the internal connec-
tions to the relays.
By using the supplied adapter, the relays connections can
be made before rack mounting the HDMI5.
The A1 and A2 buttons are used to toggle on and off the
relays.
The relays can also be setup to turn off after a given
amount of time. Or to turn on whenever specified channels
are selected. See the section "Auxiliar y Relay Options" for
relay setup information.
Using the Secure HDMI™ brackets
Star t by attaching the bracket to the back of the HDMI5
using one of the supplied screws. Tighten the screw just
enough to keep the bracket securely against the back of
the HDMI5, but still allow free movement.
Plug in the HDMI cable. Since the bracket is free to move
you can adjust it to fit any size connector. Use a wire tie to
hold the bracket against the cable.
Once the wire tie is in place you can tighten the screw to
securely hold the bracket and HDMI cable in place.
If you need to temporarily remove the HDMI cable, or posi-
tion it to another input, simply unscrew the bracket from
the back of the HDMI, there is no need to remove the wire
tie.
More wire ties can be purchased at most electronic and
hardware stores.
Using the supplied Remote Control
Install batter y using the diagram on the previous page.
Use the section of the remote controlled labeled: HDMI5/
HDVI5 for controlling the HDMI5. ( The other sections are
used to control other Zektor products).
Each button on the remote functions the same as the front
panel switch with the same name.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1 2 3 4 5 SEL A1 A2
1
5
2
3
4
1
2
3
1
2
3
1
2
3
S1
S2
S3
A1
A2
SYN
SEL
4
HDVI5/HDMI5
MAS7
CVS4
SAS6x2
Using the supplied Remote Control
Use the remote controller buttons in the section
labeled: HDMI5 / HDMI5. (The other sections control
other Zektor products)
Each button on the remote corresponds to the
same button on the HDMI5's front panel.
Auxiliary Relay Connections
N/O COM COM N/C N/O COM COM N/C
Relay 1’
s
Contacts
Relay 2’
s
Contacts
N/O = Normally Open Contacts. These contacts
are open when the relay's LED is not lit.
COM = Common
N/C = Normally Closed Contacts. These contacts
are closed when the relay's LED is not lit.
Make connections to the adapter which plugs into the HDMI5.
1
Position the clamp as shown
and lightly tighten the screw.
2
Plug in HDMI cable and use
wire tie, as shown, to hold
cable in position.
3
Fully tighten down screw to
hold clamp in place.
4
To remove, or reposition HDMI
cable, unscrew clamp, leaving
wire tie in place.