Zektor HDMI5 User Manual - Changing Switching Delays
22
HDMI5 Component Video Switch
2
HDMI5 Component Video Switch
Changing Switching Delays
The HDMI5 allows adjusting the its "Mute Delay" times, for Video
and Audio, independently. The "Mute Delay" is the amount of time
the HDMI5 mutes the output when switching inputs. For instance a
"Mute Delay" of 100ms causes the switch to mute its output 100ms
before switching to the new input. By default the HDMI5 uses a
200ms video and audio delay when switching between channels.
To adjust the Audio/Video mute delays...
Step 1: Place the HDMI5 into the Setup Mode
The HDMI5 is placed into the setup mode by pressing and
holding the Power button for about seconds.
Step 2: Enter the Switching Delay Setup Mode
Press the '5' button to enter the Delay Setup Mode.
The blue LEDs indicate the video mute delay time, if there
are no blue LEDs lit, then there is no video delay.
The red LEDs indicate the audio mute delay time, if there
are no red LEDs lit, then there is no audio delay.
No LEDs lit
= No delay.
•
One left justified LED
= 50ms delay.
••
Two left justified LEDs
= 100ms delay.
•••
Three left justified LEDs
= 200ms delay.
•••• Four left justified LEDs
= 00ms delay.
••••• Five LEDs
= 500ms delay.
•••• Four right justified LEDs
= 1 sec delay.
••• Three right justified LEDs
= 2 sec delay.
•• Two right justified LEDs
= sec delay.
• One right justified LED
= sec delay.
Step 3: Adjust Switching Delay Times
The 'SEL' button toggles between the video and audio delay
settings.
The 'A1' and 'A2' buttons are used to set the delay times.
'A1' decreases the delay time.
'A2' increases the delay time.
Press the Power button to save new settings and exit.
Note:
The new settings are saved in non-volatile memor y.
•
•
•
•
•
•
1 2 3 4 5 SEL A1 A2
Step 1: Place the HDMI5 into the Setup Mode
Press and hold the Power Button until the
display goes wild. (About seconds.)
Step 2: Enter the Switching Delay Setup Mode.
1 2 3 4 5 SEL A1 A2
After pressing '5', the standby
LED continues to flash, and the
front panel will display the cur-
rent delay settings.
Step 3: Adjust Switching Delay Times
1 2 3 4 5 SEL A1 A2
Toggle between audio
and video delays
Decrease delay
Increase delay
Exit setup mode