Zelmer 619.5 Service Manual - page 21
21
Removing the front container
Undo the two screws 72, which secure the front container handle 48 in the pin 51;
undo the two screws 71, and pull out the socket and gasket 50.
Removing the rear container
To remove the rear container remove the cap 1 and undo the valve 3. Remove o-ring
65 from the valve.
Removing the water filter
- From theupper plate 4 remove the grid 3 and take out the inlet filter 2.
- Remove the upper cover from the body 5.
- Remove: paper bag 16, gasket 7, 1 and detach the filter holder 11.
- From the body catches remove the following: foam filter 12, and gasket 6 from the side
wall of the body.
- Turn back the filter body and remove from its catches the cap 10, filter cartridge I 8 or filter
cartridge II 9.
- Undo the two screws 72, remove the setting plate 15, float 14 with gasket 13.
Removing the cord rewinder type 269
- Detach the labyrinth 10 and pull out the connection wire 1 and contacts 9.
- Remove the ring embedment 12 (for this purpose, lift up the embedment from the bottom
with a flat screwdriver).
- Remove slip rings 11 and 13 fromthe ring embedment.
- From the body 8 remove: spool 1, spring 6, lever 7.
- From the spool remove: spring 3, bearing 2.
Removing the switches
- Release the catch switch 60, lift the upper cover 62 and undo the four screws 71.
- Remove the handle 53, detach the cover 59 from the upper cover 62 by disconnecting
wiring harnesses from switches 55 and 57.
- Gently press the catches of the switch handle 58 and pull out the handle along with the
switch 55 (57) and switch guard 54 (56).
- Remove the guard 54 (56) from the switch handle 58 and push out the switch 55 (57).
Removing the power cord
- Release the catch switch 60, lift the upper cover 62, remove the front container 52 and
rear container 2.
- Undo the four screws 71 in the upper cover 62 and remove the handle 53.
- By disconnecting the wiring harness from the switches 55 and 57 detach the cover 59 and
upper cover 62, tighten the catches of the flexy tube grommet. 10 and push it through the
opening in the upper cover 62.