ZENEC ZE-5.1D Operation Manual - page 18
REMOTE CONTROL BUTTONS & OPERATION
1. Mute On/Off
When the amp powered on, the MUTE button on the remote control is used for instantaneous
lowering of the volume level to zero. Eliminating MUTE can be done by pressing the MUTE button
again, or else adjust volume up or down.
2. Input Selection
The INPUT SELECT button on the remote control provides manual switching of the input coming
into the system. The fi rst press of the INPUT button displays the current input source. The
selection switches in order from -> Optical -> Coaxial-> Input1 -> Input2 and then back to Optical
again. Input switching is possible while the source is displayed on the screen. If there is an error
in optical or coaxial input, the display will blink continuously. In this circumstance, all controls are
available while blinking. The ZE-5.1D has source memory: When you power the unit off and then
on again, it will remember the last source selected, and return to that source automatically.
3. Test Tone
The ZE-5.1D amp features a test tone mode to check, if all speakers are connected properly. When
this button is selected (on the remote control), white noise of a fairly low volume is forwarded to
each of the 5 main speakers in order from -> Front Left -> Center -> Front Right -> Rear Right ->
Rear Left, alternating every 2 seconds until the button is pressed once more.
Note: There is no test tone for the SUB output.
4. Set-Up
This button causes the On Screen Display to open the menu for setting up the ZE-5.1D amplifi er.
In this menu window, the selection, function, and control of the selected function sections can be
accomplished. The Set-Up menu allows control of:
• Pro Logic Selection
• Dynamic Range Compresion Selection for Dolby 5.1 material
• Crossover Filter selection for LPF and HPF used in Bass Management
• INPUT1 Level
• INPUT2 Level
• Channel level (input gain) control
Pressing the Set-Up button on the remote while the menu is displayed on-screen, will cause the
menu to hide. This button is also used to return to the main Set-Up menu from the channel level
control menu.
5. Menu Up/Down
When the menu is displayed on the OSD (On-Screen Display), the function to be controlled can
be selected by the Up/Down buttons. The buttons are set up in a circular pattern on the remote,
for ease of use.
6. Selection Left/Right
After the selection of function using the Menu Up/Down button, function-dependant values can be
changed using the LefVRight buttons on the Remote Control. As soon as the value is changed,
the new value is displayed without requirement of confi rmation. For value changes, the left button
is used for decreasing values, and the right button is used for increasing values.
18
ZE-5.1D Manual E+D
27.02.2004, 14:32 Uhr
18