ZENEC ZE-5.1D Operation Manual - page 21
21
OPERATION GUIDE
1. Input Source Selection
To select the input source for the system, the system should be turned on, then:
1) Push „INPUT“ selection button on remote controller
2) Continuing to push the „INPUT“ selection button while the input is displayed on the monitor or
TV makes a change in the input source as follows: OPTICAL -> COAXIAL -> INPUT1 -> INPUT2
-> OPTICAL (in circular order).
If there is an error in the data received via the optical or coaxial line the display will blink
continuously. For more details, please see section 13. Digital Error Detect.
2. Listening Mode Selection
The system provides three kinds of listening modes:
Surround Listening Mode
This mode is selected with a full set of 5.1 speakers connected . This mode is recommended for
use, while Dolby Digital or Pro Logic is working.
Phantom 4.1 Listening Mode
This mode is selected when a center speaker is absent. This mode is recommended for use with
Dolby Digital or Pro Logic when working without a center channel speaker
2-Channel Stereo Listening Mode
When this mode is selected, the rear channels are identical to the front channels. That is, the front
left and right channels are copied to rear left and right channels respectively In this mode, center
signal is not produced, but SUB signal is produced. Pro Logic is automatically deactivated in this
mode.
To select a listening mode described above, the system should be turned on and:
1) Push „LISTEN MODE“ selection button on remote controller.
2) Continuing to push „LISTEN SELECTION“ button while it is displayed in monitor or TV makes
a change in the listening mode as follows: SURROUND -> PHANTOM 4.1 -> 2-STEREO (in
circular order). While Pro Logic is off for a PCM source (CD or line input), if the listening mode is
‚ SURROUND“ or „PHANTOM 4.1 „ there is no surround and center sound. For surround sound,
Pro Logic should be set to ON in setup menu, or alternatively, „2-STEREO“ listening mode can
be selected.
3. DRC Dynamic Range Compression On/Off
This function currently supports only Dolby Digital 5.1 sources. For other programs and non-
surround listening modes, this function is not effective. When this function is on, a high level
signal (e.g. explosions, bombing, jet passing by, etc) is compressed or attenuated, while having no
infl uence on low level signal (like speech). When this function is off, the output is reproduced with
full dynamic range as recorded on disc.
ZE-5.1D Manual E+D
27.02.2004, 14:32 Uhr
21