Zenesis Z-101 A User Manual - page 15
NOTE: Remote start reservation type can be changed through the User
Programmable Options.
3.4 Temperature Status Press and hold
for 2 sec
The interior temperature of the vehicle will be displayed as a series of LED
flashes and beeps on the remote control.
3.5 Paging (302 A/AS)
(
Press and hold Function Button for 2 seconds and then press and release Trunk
Button)
Paging will alert the user when the alarm has been triggered. If the Remote Beep
Mute is ON, the LED’s on the 2-way remote control will blink alternatively. If the
Remote Beep Mute is OFF, the remote control will beep rapidly. Pressing
,
,
or
will stop the alert on the remote control. Wait for 5 seconds and press
to find out the status of the vehicle.
Paging ON
Paging OFF
NOTE: If Paging is OFF, battery life will be extended.
3.6 Remote Control Beep Mute
(Press and hold Function Button for 2 seconds and then press and release
Unlock Button)
Temperature
Remote Control LED
Less than or equal to -10°C (14°F)
2 BLUE LED flash & 2 beep
-9°C (16°F) to 0°C (32°F)
1 BLUE LED flashes & 1 beeps
1°C (34°F) to 10°C (50°F)
3 RED & BLUE LED flashes & 3 beeps
11°C (52°F) to 20°C (68°F)
1 RED LED flashes & 4 beeps
Greater than 20°C (68°F)
2 RED LED flashes & 5 beeps
Remote Control
1 BLUE LED flash & 1 beep
Remote Control
2 BLUE LED flashes & 2 beeps
2.4 Vehicle Status Press and release
The status of the vehicle will be displayed on the 2-way remote control. The
following table describes the different situations. Please note the priority (top to
bottom). If a status condition is met, any other conditions below it will not be
checked. For example, if the remote start condition is displayed, door lock
condition will not be shown.
2.5 Panic (101 A/AS) Press and hold
for 2 sec
If there is a potential threat, you can alert those around you by using this feature.
The siren will sound for 2 minutes and the parking lights will flash. Press either
or
to turn off panic mode. Alternatively, you can use the Z-PASS (if installed)
to turn off the panic mode by entering your PIN code.
2.6 Remote Start Press and hold
for 2 sec
Successful remote start:
Status
Remote Control
Large shock
Alternating BLUE and RED LED flashes 8
times & beeps 8 times
Warning shock
Alternating BLUE and RED LED flashes 7
times & beeps 7 times
Hood open
Alternating BLUE and RED LED flashes 6
times & beeps 6 times
Trunk open
Alternating BLUE and RED LED flashes 5
times & beeps 5 times
Trunk unlocked
BLUE LED flashes normally two times &
beeps 2 times
Door unlocked
RED LED flashes fast 4 times & beeps 4 times
Door locked
RED LED flashes fast 3 times & beeps 3 times
Remote Start (with Key)
Alternating BLUE and RED LED flashes
normally 3 times & beeps 3 times
Remote Start (with
Remote Control)
Alternating BLUE and RED LED flashes fast &
beeps 3 times
Vehicle
3 parking light flashes &
3 siren chirps
Remote Control
3 BLUE LED flashes &
3 beeps