Zenesis ZN-502 A User Manual - page 13

2.7   Remote Start ButtonⅢ  2+ sec 

Successful Remote Start 

Failed Remote Start 

If Button Ⅲis pressed for 2+ seconds while remote start is on, remote start will turn  

off.  The default remote start engine running time is 15 minutes. The time can be 

changed through the User Programmable Options. 

CAUTION: Do not use the remote start feature if the vehicle is in an enclosed area.   

Do not use the remote start feature where laws prevent its usage.  Do  

not turn the key to the Start position or else damage may be done to the 

starter motor.  Ensure that the parking brake (emergency brake) is  

always engaged.  Do not use the remote start feature with convertible  

and/or open concept cars such as utility vehicles.

13 

Remote Control 

     &                will blink until remote start is 

turned off.  1 beep will occur if the main 

control module communicates with the 

remote control.  5 beeps will occur after 

remote start is successful. 

Vehicle 

1 parking light flash & 1 siren chirp if the 

main control module communicates with the 

remote control.  5 parking light flashes & 5 

siren chirps after remote start is successful. 

Reason for Failure 

Vehicle 

Remote 

Control 

Key at ON Position 

1 parking light flash & 1 siren 

chirp 

3 beeps 

Open Door 

3 parking light flashes & 3 

siren chirps 

3 beeps 

Open Hood and/or 

Trunk 

4 parking light flashes & 4 

siren chirps 

3 beeps 

Failed Remote Start 

Reservation for Manual 

Transmission Vehicles 

7 parking light flashes & 7 

siren chirps 

3 beeps