Zenesis ZN-502 A User Manual - 3.17 Z-Pass Touch
3.16 Shock Sensor Sensitivity Adjustment
The sensitivity of the shock sensor can be controlled by turning a dial on the shock
sensor module. Turn the dial according to the amount of sensitivity that is desired.
Keep in mind that turning the sensitivity to its maximum can result in false alarms
3.17 Z-Pass Touch
The system can be armed or disarmed by “touching” the Z-Pass Touch with a PIN
of 4 - 10 digits.
1. PIN Registration
a. Turn Key to ON position (Engine OFF)
b. Press ENTER until ALL OUTER LED’s light up.
c. Enter 4 - 10 digit PIN. In order to toggle between “1 - 5” and “6 - 0”,
press “SHIFT”.
d. Once all of the numbers are entered, press ENTER until all LED’s
blink
3 times.
2. System Arm/Disarm
a. Press ENTER until ALL LED’s blink 1 time.
b. Enter 4 - 10 digit PIN.
c. Press ENTER until ALL LED’s blink 4 times.
d. System will Arm or Disarm accordingly.
3. Driver Call
a. Press DRIVER CALL 3 times while the system is in armed mode.
b. All LED’s will blink quickly and 2 siren chirp / light flash will occur.
Driver call will be sent to the 2-way remote control.
4. Discrete mode
- Hold driver call button until outer LED’s blink once.
- To turn off discrete mode, hold down driver call button until outer LED’s
blink twice. Discrete mode can be done in armed or disarmed mode.
Vehicle
Full Shock
Continuous parking light flash and siren
sound.
Remote Control
Tune
Warning Shock
Beep
10 second parking light flash and siren
sound.
24