Zenesis ZN-502 A User Manual - page 20

3.9    Remote Control Registration 

1.  Insert key and turn the key to ON position (engine is OFF). 

2.  Press brake pedal 4 times. 

3.  On the 4th press, hold the brake pedal down. 

4.  3 parking light flashes and 3 siren chirps will confirm remote control program-

ming mode. 

5. Press 

Button 

Ⅰ

(Lock Button) . 

6.  After each remote control is added, there will be a confirmation of 2 parking  

light flashes and 2 siren chirps.  You can add up to 3 2-way remote controls  

and 2 1-way remote controls per system. 

7.  Once the key is turned to the OFF position or 10 seconds without adding a 

      remote control passes, the system will exit remote control programming 

      mode. 

※

 Each time a remote control is added, all remote controls must be  

    reprogrammed to the system. Adding a remote control erases  

    previously stored remote controls from the system. 

3.10   Remote Start Reservation 

Manual transmission vehicles require remote start reservation in order to ensure 

that the vehicle is properly prepared for remote start.  There are 2 remote start  

reservation modes: automatic and manual.  Please note that automatic and  

manual do not refer to the transmission type.  Rather, automatic and manual refer  

to the type of remote start reservation. 

1. Automatic Remote Start Reservation (Default) 

a.  Before turning off the engine, put the transmission into Neutral.  Ensure that  

the parking brake (emergency brake) is engaged.  Take foot off of the foot 

brake. 

b.  Turn the key to the OFF position.  The engine should still be running. 

c.  Exit the vehicle within 2 minutes. 

d.  Once the last door is closed, the engine will turn off. 

e.  Arm the system.  Remote start is ready to be used. 

2.  Manual Remote Start Reservation 

a.  Before turning off the engine, put the transmission into Neutral.  Ensure that  

the parking brake (emergency brake) is engaged.  Take foot off the foot brake. 

b.  Press  Button Ⅲ  for 2 seconds. 

c.  Turn the key to the OFF position. The engine should still be running. 

d.  Exit the vehicle within 2 minutes. 

e.  Once the last door is closed, the engine will turn off. 

f.  Arm the system. Remote start is ready to be used. 

NOTE1: Remote start reservation type can be changed through the User  

Programmable Options.    

NOTE2: If a door, trunk, or hood is opened, remote start reservation will be 

cancelled and remote start will not be available. 

20