Zenith PCZ3000 Installation And Setup Manual - page 10
Troubleshooting
Troubleshooting
Problem
Possible Cause(s)
Possible Solution(s)
Installation
Old card is hard
• Screws not removed.
-Remove two screws holding old card in place.
to remove.
• Snug fit.
-Grasp old card by the hook provided and pull firmly enough
to free old card from internal connector.
Green light is not lit
• Card not completely installed.
-Be sure card is firmly seated into internal connectors.
when TV power is
restored and TV is on.
Macintosh Computers (Refer to Owner’s manual for operating instructions)
Computer does not work. • Is proper video format
-Select SVGA for a Macintosh, see computer
selected?
owner’s manual.
Macintosh connector
• Macintosh adapter needed.
-Install optional PCZ40 Macintosh cable adapter.
does not fit jack.
No Notebook display.
• Display toggle key set
-Locate toggle key and set to “External”.
to “Internal”.
PC Computers (Refer to Owner’s manual for operating instructions)
Computer does not work. • Is proper video format
-Select VGA for a PC, see computer
selected?
owner’s manual.
No Notebook display.
• Display toggle key set
-Locate toggle key and set to “External”.
to “Internal”.
P A G E 1 0
206-3492-A