Zenith PCZ3000 Installation And Setup Manual - page 11
Computer/PCZTV Loop-Out Setups
206-3492-A
Video cable
from monitor
Actual
appearance of
components
may vary
Cable for
"video mirror"
Back of computer
VIDEO
ANTENNA
CABLE
R- AUDIO- L
S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
AUDIO OUT
Master TV's Computer
output to other TVs
in the "Daisy Chain"
Computer Monitor
Computer
ABC
ABC
ABC
ABC
Computer
input to
Master TV
ABC
Video Out
C
O
M
P
U
T
E
R
I
N
Setup for Looping-Out S-Video/Video
Computer Image to a Master TV & other TVs
1. With the Computer and TV disconnected from
power and the PCZ3000 Scan Conversion Card
installed, make S-Video or Video connections as
shown.
2. Connect Computer and TV(s) to power, first turn
on the PCZTV, TVs, and then the Computer.
3. On the PCZTV, select TV source “REAR COMPUTER
NTSC OUT” using the TV’s Source menu.
Viewing Sources Note: Be sure to follow instruc-
tions supplied with your computer, and TV(s) for
selecting viewing sources. Computer image should
appear on your Master and other TVs connected in
series.
VIDEO
ANTENNA
CABLE
R- AUDIO- L
S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
AUDIO OUT
ABC
ABC
ABC
Video cable
from monitor
Actual
appearance of
components
may vary
Cable for
"video mirror"
Back of computer
Master TV's Computer
output to other TVs
in the "Daisy Chain"
Computer Monitor
Computer
ABC
Computer
input to
Master TV
ABC
Video Out
C
O
M
P
U
T
E
R
I
N
S-Video Loop-out from Master TV to other TVs
Video Loop-out from Master TV to other TVs
After you install the scan conversion
card into your 46 Series Presentation TV,
you can “daisy-chain” the TV’s
S-Video or Video output to other TVs:
Send the computer image to a “Master”
TV and then to other TVs connected in a
daisy-chain series
Notes
• These setups require factory menu item 25
NTSC SCANCARD, default value “0” to be
changed to “1”. (See your 46 Series
Presentation TV’s Installation Guide for instruc-
tions regarding how to change factory menu
item default values.)
• The cables shown in each of these setups are
not supplied with the scan card or with the 46
Series, Presentation TVs. See your Zenith dealer
to purchase the necessary cables or for further
information.
P A G E 1 1
SOURCE
REAR COMPUTER NTSC OUT
PRESS:
SOURCE TO CHANGE
ENTER TO ACTIVATE