2gig Technologies Go!Control Panel User Manual - page 17
Burglary Protection
©2013 2GIG Technologies Inc. All Rights Reserved.
16
The alarm memory automatically clears the
next time the system is armed. You can also
check the Clear Alarm History button and
press Ok to manually clear the alarm
memory (24‐hour fire and CO sensors that
are still violated remain in alarm memory).
Optional 2-Way Voice
Communications
2‐way voice communications provides a
method for alarm verification and can
provide emergency assistance. The Control
Panel contains a built‐in microphone that
can monitor sounds around the area of the
Control Panel. The built‐in microphone and
speaker allows 2‐way voice communications
with a Central Station operator after an
alarm. The operator can converse with
people in the premises through the Control
Panel’s speaker and microphone.
Your installer can set the system to use 2‐
way voice communications after an alarm
and/or after a panic alarm is triggered.
NOTE: If a panic alarm or sensor is set for a
silent alarm, the operator can only listen
and not be able to talk. This is for your
protection.
KEY FOB ARMING AND
DISARMING
Your system may be equipped with one or
more wireless key fobs. Up to eight key fobs
can be used to control the system remotely.
Each key fob has four buttons and can
perform five functions. A User Code is not
required when arming or disarming the
system with a wireless key fob.
There are several key fob options that can be
set by the installer. See "Installer
Programmed Options" on page 38.
Key Fob Arming to Stay Mode
•
To arm the system to Stay Mode using a
key fob, press the
Stay button.
NOTE: Depending on setup options, if there
are open perimeter doors or windows,
the system may not allow arming to Stay
Mode with a wireless key fob. See
"Installer Programmed Options" on page
38.
Key Fob Arming to Away Mode
•
To arm the system to Away Mode using a
key fob, press the
button.
NOTE: Depending on setup options, if there
are open perimeter doors or windows,
the system may not allow arming to
Away Mode with a wireless key fob. See
“Installer Programmed Options” on
page 38.
Key Fob Disarming
•
Using a key fob to disarm the system
from Stay or Away Mode, press the
Disarm button.
NOTE: To use your key fob to disarm your
system, this option must already be
enabled by your installer.
Key Fob Emergency
•
To trigger an emergency alarm using a
key fob, press the
Away button and
Disarm button at the same time for 5
seconds.