2gig Technologies Go!Control Panel User Manual - page 34
System Toolbox
©2013 2GIG Technologies Inc. All Rights Reserved.
33
IMPORTANT: Test your Security System
weekly to ensure continued protection
and proper system operation.
You can test the cellular radio connection
using the Toolbox.
1
From the Home Screen, press Security.
2
From the Security Screen, press Menu.
3
From the Menu Screen, press Toolbox.
4
To access the Toolbox, enter the Master
User Code.
5
To select the Toolbox Screen (3 of 3), use
the ← and → arrows.
6
On the Toolbox Screen (3 of 3), press Cell
Phone Test.
7
To begin the test enter the Master User
Code again.
The system displays the test status
screen. The top part of the screen shows
each function that is being tested.
8
Use the ↑ and ↓ arrows to scroll
through the status messages. The
bottom part of the screen shows the
results of each test.
9
If any tests fail, note what messages
were displayed, and contact your alarm
installer to troubleshoot your system.
10
After the testing is complete, press Ok to
return to the Toolbox.
CHIME OPTIONS
On doors and windows monitored by
sensors, the system can sound a chime to
announce that the door or window was
opened. Sensors can also be set to have the
Control Panel say the name of the opening.
TIP:
The chime and voice
announcements only sound while
the system is disarmed.
At the time of installation, the installer
programs each sensor’s chime option. The
person with the Master User Code can
change the chime options for each sensor to
further customize the system as desired.
TIP:
As a global system option, the
chimes for all the system’s sensors
can be turned on or off using the
Chime check box on the Menu
Screen.
To setup the chime options individually for
each sensor, do the following:
1
From the Home Screen, press Security.
2
From the Security Screen, press Menu.
3
Note the Chime and Voice check boxes
on the Menu Screen. The Chime check
box button is a toggle that turns the
chimes on or off for all the system’s
sensors. The Voice check box button is a
toggle that turns the voice
announcements for the system’s
messages on or off (except alarm voice
messages).
4
From the Menu Screen, press Toolbox.
5
Enter the Master User Code to access
the toolbox.
6
From the Toolbox Screen (1 of 3), press
Chime Setup. The Chime Setup Screen
displays each of the installed sensors