3Com AccessBuilder 500 User Manual - page 55
Quick Configuration
1-35
Connecting to the Internet or a PPP Router
To connect to an Internet router or to a router using Point-to-Point
Protocol (PPP), enter
IN
at the command prompt on the Quick
Configuration screen to display the screen illustrated in
Figure 1-19
.
Figure 1-19
Connecting To The Internet Or PPP Router
Complete the fields on this screen as follows:
If you are connecting to the Internet, your service provider will be able to
give you the correct values for each of these fields.
If you are connecting to a remote PPP router, check with the system
administrator of the remote network for the correct values for these fields.
Name of your Internet Provider or remote site
Type the name of your
Internet service provider or of the remote unit that connects to the remote
IP network.
ISDN Number of the remote unit
Type the ISDN number of the
remote unit that connects to the remote IP network.
Call Type
Set the Call Type required for your ISDN line. Toggle this field
to the Call Type required by your ISDN service provider.