3Com AccessBuilder 500 User Manual - page 56
1-36
C
H
A
P
T
E
R
1:
G
E
T
T
I
N
G
S
T
A
R
T
E
D
IP Address of this unit’s LAN
Type the IP address of this unit. This is
the address you entered on the Name screen.
IP Mask of this unit’s LAN
Type the IP subnet mask you entered for
this unit on the Name screen. See
Appendix A
for more information
about subnet masks.
IP Address of this end of the ISDN link
By default this field is set to
UNNUMBERED
which allows unnumbered links to be used. This option
is suitable for most network configurations. See
Appendix A
for more
information about numbered and unnumbered links.
If you want to use numbered links, you must enter an IP address for this
port that is on a different network or subnetwork than the unit’s IP address.
IP Address at the other end of the ISDN link
By default this field is
set to
UNNUMBERED
indicating unnumbered links are being used. If
you are using numbered links, type the IP address of the remote ISDN
port on the unit to which you want to connect. It must be on the same
network or subnetwork as the local ISDN port.
IP Mask of the ISDN Link
If you are using unnumbered links, leave this
field set to
UNNUMBERED
. If you are using numbered links, type a
subnet mask suitable for use with the IP addresses you have selected
for the ISDN ports at both ends of the link. See
Appendix A
for more
information about subnet masks.
P Address of the Remote Host
By default this field is set to
INTERNET
.
This is the default route and all IP traffic not destined for the LAN port is
passed to the remote unit on the ISDN number you configure in this
screen. If you want to route IP traffic to a specific unit, type the IP address
of remote host to which you want to connect.