3D Printing Systems UP MINI User Manual - 3. Operation
UP Mini 3D Printer User Manual
Mount the Extruder Head
Clip in the Extruder head, with its magnetic
clip system. The fan goes on the left h
side. Then plug in the ribbon cable connector.
The extuder has a LED lighting to light the model
during printing. Double tap the front intilise button to
switch on or off the internal lighting.
Load the Roll of filament
1. Open the foil bag that
2. Load the Spool onto the spool holder, ensuring the
filament unwinds as per
3. Feed the end of the filament between the roll
guide.
4. Feed the filament into the feeder tube and feed about 10cm out the other end of the feeder
tube.
5. Feed the filament and tube inside the
6. Insert the end of the ABS filament into the printer head.
Connect the Printer
1.) Connect the USB cable between the Computer and the Printer
hand side).
2.) Connect the power supply to th
hand side of the printer, plug the power supply to the mains outlet.
3.) Visit
www.3DPrintingSystems.com/support
software for MAC and Windows
software install procedure in 3.1.2
4.) Power on the printer on at the back.
Slide the Perfboard into
binder clips in order to hold the Perfboard onto the platform.
remove the Perfboard to remove printed models from the printer.
3. Operation
3D Printer User Manual
Mount the Extruder Head
Clip in the Extruder head, with its magnetic
clip system. The fan goes on the left hand
side. Then plug in the ribbon cable connector.
The extuder has a LED lighting to light the model
ing printing. Double tap the front intilise button to
internal lighting.
Load the Roll of filament
Open the foil bag that contains the filament.
onto the spool holder, ensuring the
as per above diagram.
Feed the end of the filament between the roll filament
Feed the filament into the feeder tube and feed about 10cm out the other end of the feeder
Feed the filament and tube inside the back of the top door.
Insert the end of the ABS filament into the printer head.
Connect the USB cable between the Computer and the Printer
Connect the power supply to the “Power interface” located
of the printer, plug the power supply to the mains outlet.
www.3DPrintingSystems.com/support
to download the latest
software for MAC and Windows and install the software. (
software install procedure in 3.1.2)
Power on the printer on at the back.
into the platform (between the groves) and attach the
binder clips in order to hold the Perfboard onto the platform.
o remove printed models from the printer.
Warning:
Do not let go of the
otherwise it will unravel itself and tie itself in a knot, which
will then cause a block in the extruder head and several hours
of unwinding the spool manually to find the knot!
Operation
11
Feed the filament into the feeder tube and feed about 10cm out the other end of the feeder
Connect the USB cable between the Computer and the Printer (left
e “Power interface” located on the left
of the printer, plug the power supply to the mains outlet.
to download the latest
(refer to the
and attach the
binder clips in order to hold the Perfboard onto the platform. TIP: Always
o remove printed models from the printer.
Do not let go of the end of the filament,
itself and tie itself in a knot, which
will then cause a block in the extruder head and several hours
of unwinding the spool manually to find the knot!